Ntpdate not updating Live brown girls sex chat

Rated 3.97/5 based on 539 customer reviews

However, and to protect against broken hardware, such as when the CMOS battery fails or the clock counter becomes defective, once the clock has been set, an error greater than 1000s will cause ntpd to exit anyway. I have made one additional change to the configuration and it seems to do the trick – It is probably a bit of a hack!

but it seems to work…Modify the ntpdate.service file to add one more line: [Unit] Description=Network Time Service (one-shot ntpdate mode) Before=ntpd.service [Service] Type=oneshot Exec Start=/usr/bin/ntpd -q -g -x Exec Start=/sbin/hwclock --systohc Remain After Exit=yes [Install] Wanted By=multi-user.target [email protected]:/lib/systemd/system# [email protected]:/lib/systemd/system# timedatectl Local time: Sun 2013-06-09 BST Universal time: Sun 2013-06-09 UTC RTC time: Sun 2013-06-09 Timezone: Europe/London (BST, 0100) NTP enabled: no NTP synchronized: yes RTC in local TZ: no DST active: yes Last DST change: DST began at Sun 2013-03-31 GMT Sun 2013-03-31 BST Next DST change: DST ends (the clock jumps one hour backwards) at Sun 2013-10-27 BST Sun 2013-10-27 GMT [email protected]:/lib/systemd/system# Dr.

A Google search for my location “ntp server ireland” returns the website which you can search for your location.

For Ireland I get: # This is the most basic ntp configuration file # The driftfile must remain in a place specific to this # machine - it records the machine specific clock error driftfile /etc/ntp.drift logfile /var/log/# NTP Servers for Ireland from server 0org server 1org server 2org server 3org # Using local hardware clock as fallback # Disable this when using ntpd -q -g -x as ntpdate or it will sync to itself # server 127.127.1.0 # fudge 127.127.1.0 stratum 14 # Defining a default security setting restrict 192.168.1.0 mask 255.255.255.0 nomodify notrap The driftfile specifies the file that is used to store information about previous responses from the NTP servers you are using.

H [[email protected]: Active] config # tcpdump udp port 123 tcpdump: WARNING: eth0: no IPv4 address assigned tcpdump: verbose output suppressed, use -v or -vv for full protocol decode listening on eth0, link-type EN10MB (Ethernet), capture size 108 bytes .201229 IP ACC-GTM-01.

The reason for this is given in the ntpd man page ( Most operating systems and hardware of today incorporate a time-of-year (TOY) chip to maintain the time during periods when the power is off.

When the machine is booted, the chip is used to initialize the operating system time.

You'll probably geta quick step into line, and then ntpd should (Within a few monites) eventually get into sync and start to track the clock of one of the servers.

Checkout the ntpd doc on the internet for various status results of the ntp servers. COM.ntp: NTPv3, Server, length 48 [[email protected]: Active] config # ntpq -np remote refid st t when poll reach delay offset jitter ============================================================================== 10.2.104.47 .

Leave a Reply